Abs error codes
From gt4dc_wiki
Revision as of 22:17, 25 August 2011 by Two OH five (Talk | contribs)
NOTE: This is only relevant for GT4’s fitted with ABS
To find out what ABS errors have been detected, you need to switch it into diagnostic mode. To do this:-
- Switch off the ignition.
- Locate the diagnostic box, under the bonnet behind the passenger suspension turret.
- The lid of the box hinges open and on the back of the lid there is a pinout of the connector.
- Locate the E1 and TC terminals and using a paperclip, piece of wire etc connect these two terminals together.
- Go back into the car and switch the ignition to on (but do not start the car) and observe the ABS light.
- It will do one of two things:-
- A steady flashing indicates that there are no stored codes (as shown in the image above)
- Otherwise, count the number of flashes and write down the number. There is a pause between each number, so if you count 5, then observe a pause, then count 1, that makes error code 51.
Code Diagnosis
11 | Open shorted relay circuit. Check modulator wiring harness, solenoid relay, solenoid relay wiring harness and solenoid relay connector |
12 | Short in solenoid relay circuit. Check modulator wiring harness, solenoid relay, solenoid relay wiring harness and solenoid relay connector |
13 | Open pump motor relay circuit. Check modulator wiring harness, pump motor wiring harness, pump motor relay circuit and pump motor connector. |
14 | Short in pump motor relay circuit. Check modulator wiring harness, pump motor wiring harness, pump motor relay circuit and pump motor connector. |
21 | Open or short in ABS solenoid for right front wheel. |
22 | Open or short in ABS solenoid for left front wheel. |
23 | Open or short in ABS solenoid for right rear wheel. |
24 | Open or short in ABS solenoid for left rear wheel. |
31 | Problem in right front wheel speed sensor circuit |
32 | Problem in left front wheel speed sensor circuit. |
33 | Problem in right rear wheel speed sensor circuit. |
34 | Problem in left rear wheel speed sensor circuit. |
35 | Open in left front or right rear wheel speed sensor (WSS) circuit. |
36 | Open in right front or left rear WSS circuit |
37 | Faulty rear speed sensor rotor. |
41 | Battery voltage too low or high (under 9.5 volts or over 16.2 volts). Check battery and charging system. |
51 | Pump motor is locked or pump motor circuit is open. Check pump motor, motor relay, wiring harness and modulator ground connections |
Always on | Malfunction of ABS module. |